For Replay Camera Technical Support, Warranty, or Repair issues please contact:

Phone: 805-480-9800    Fax: 805-480-9800    Email: sales@stableimaging.com
http://replayxd.com/support/

Reformat SD Card :
Official SD Card Association SD, SDHC, SDXC formatter download:
https://www.sdcard.org/downloads/

Mounting Instructions:

Standard Mount:Simply remove the clamping ring or "band" from your guns feed-neck and replace with the R7 Ring. If any gaps are left open at the bottom of the feed-neck, utilize one of the included black rubber bands to cover up the gaps to keep paint and dirt out, by simply sliding it down over the gaps on the feed-neck first. In case it is NOT obvious, the R7 ring now acts as the tightening device for your loader.

Standard Mount (Alternative Mounting Method): Utilizing one of the included black rubber bands, simply slide one to the top of the neck of any loader, then slide on the R7 ring over the black rubber band, center it forward, then tighten.Then, simply slide the loader into ANY feed-neck and tighten normally.

Planet Eclipse Mount:  Simply remove the current tightening hardware (thumb screw and feed lever) on the stock feed-neck of any Geo, Etek, Ego, or Etha. Remove the locking screw from the R7 Planet Eclipse Ring. Next slide the special sized R7 ring over the feed-neck and utilize the provided locking screw to tighten any loader securely to marker, as it replaces the thumbs screw from the original hardware.

R7 Picatinny Mount: Utilizing the included black rubber bands, wrap both rubber bands', one on top of the other, in the location where you will mount the included R7 Picatinny ring (Keep in mind that the red buttons must be orientated UP), then tighten the two sections together over top of the dual, black rubber bands.Then mount your camera to any REAL firearm, AIRSOFT, or Paintball gun with Picatinny rails.

GOGGLE MOUNTING: Choose the area on the goggle that will best suite mounting the R7 Replay in the desired direction and angle.You may have to drill a hole, but we simply pushed the supplied 1/4-20 X 3/8 Phillips head screw right through the vents on these Tippmann goggles shown below.

-Add a second washer, depending on the thickness of the mask where you wish to mount the camera.

-The Included Delrin ring that is used on the patented R7 feed-neck mount for your paintball marker has a threaded hole built in on one side.Screw that on snug enough where the camera will not move, but do not over tighten, it is not necessary to make it super tight, since you may want to adjust it on the fly.

If you STILL have any questions, please contact us at customerservice@r7usa.com